When that start happening then it is predictable that the volume will cut off and only it it resets by cycling power. Some time the coil split just have no effect or the piezo volume becomes the entire system volume. the Magnetic pickups become inverted in the way that neck becomes bridge position and bridge position becomes the neck. When the problem hapens the guitar starts behaving oddly. I am certain that it has to do with the guitar preamp. Is a shame that I am finding my self on this predicament because all this gear is extremely expensive. This does not happen with my passive guitars. The common denominator are my MusicMan Monarch Majesty Guitars (2X6 string and 1X7 string). My Kemper cuts out to about 30% and then it just cuts to 0% while playing. Which software revision is installed? We are at 5.4.1 Release. Is the issue related to particular Modes or Rigs or Slots? - No, the same behaviour in all the modes cables, speakers.? - I tried different guitar cables with the same result Have you checked the connected monitoring equipment. the Speaker Output? - All outputs affected, main outputs, headphones. What is the level of the relevant output volume - not Master Volume - but for example Monitor Output Volume in dB? - No idea but the problem is in the input signal not in the outputĭoes the issue affect all outputs or just one e. Output LED - is this still reflecting a signal?.- The output led shows no signal as there is no input affected Control Change #7? - No MIDI involved in the problem I tried different patches with the same result. Volume Pedal - where is the level of the Volume Pedal controller in the System Settings? If that isn't at maximum, what is causing it? Which socket(s) is/are assigned to the function Volume Pedal? What is connected to those sockets? What if you disconnect pedals or disable unused sockets? - No volume pedal connected to the kemper. I tried two input sources ( input and alternative input) with teh same result. The Kemper was not connected to any audio interface just connected to the power amp. So, the activation of your audio interface could cause the Front Input to mute. Input Source - while your Input Source is for example set to "SPDIF Input Reamp" the Front Input is still functional, but only until an SPDIF cable gets connected AND a synchronization signal is received at the Profiler's SPDIF In. Input LED - is the input LED still functional or dead or frozen? - The input LED shows no signal Which software revision is installed? We are at 5.4.1 Release.īurkhard, I thougth the list of questions was directed to MetalMauce. Is the issue related to particular Modes or Rigs or Slots? What is the level of the relevant output volume - not Master Volume - but for example Monitor Output Volume in dB?ĭoes the issue affect all outputs or just one e. Output LED - is this still reflecting a signal?. Volume Pedal - where is the level of the Volume Pedal controller in the System Settings? If that isn't at maximum, what is causing it? Which socket(s) is/are assigned to the function Volume Pedal? What is connected to those sockets? What if you disconnect pedals or disable unused sockets? Input LED - is the input LED still functional or dead or frozen? Complete loss of input signal is not the same as drop of output signal!? If you don't hear anything but the Tuner is still functional it's probably not an issue with the input signal. So far I see no evidence, that these are the "same issues".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |